Check the feature for error-free functioning as follows:
Step Action
1. Seize an analog line.
2. The correct signalling method is automatically detected.
7.6.10 Temporary Signalling Method Changeover
Definition
The signalling method can be temporarily changed while a connection is set up. Normally, this is done
with a code. All subsequent digits are transmitted to the central office in the desired mode.
This temporary state is terminated when the handset is replaced.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Enquiry DTMF mode is deactivated when the enquiry feature is activated.
Voice Mail DTMF mode is automatically activated when an extension configured as voice mail is
selected.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Set up a connection.
2. Change over to DTMF mode using the procedure described.
3. All digits that are now dialled are transmitted in DTMF mode.
Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (13 of 21) [06/04/2000 13:10:46]
To Next Page
Loading...
