Siemens Hicom 150 E Office - Table 3-16 SLMO8;SLMO24 - LED State; Table 3-17 SLMO8; SLMO24 - Cable 1 Assignment (SU X8)

Figure 3-17 SLMO8 / SLMO24 (S30810-Q2901-X / S30810-Q2901-Xxxx)
LED states and their meaning
Table 3-16 SLMO8/SLMO24 - LED state
Red LED Green LED State Action
Off Off Board not receiving power / is not
plugged in correctly.
Board is deactivated.
Check plug contact on board.
On Off Board is receiving power / board test in
program.
Board is defective if state remains
unchanged (i.e. board test unsuccessful).
Replace board.
Loadware loading operation was not
successfully completed. Board is
defective.
Replace board.
Error was detected on board. Board is
deactivated (does not apply to errors
detected by test loops) / board was
deactivated by means of Hicom Assistant
E.
Check whether board was
deactivated by Hicom Assistant
E. If not, replace board.
Flashing Off Loadware is being loaded.
Off On Loadware operation was successfully
completed / board is operational (idle
state).
Off Flashing At least one extension is activated.
Cable and SU connector assignment (backplane)
Table 3-17 SLMO8 / SLMO24 - cable 1 assignment (SU X8)
Colour
group
Pair a-wire b-wire SU conn. SLMO8
SLMO24
Notes
BP: X8
1 1 wht/blu 19 1a Access 1
blu/wht 39 1b
Hicom 150 E Office Rel.1.0 Service Manual - 3.3 Peripheral boards
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_32.htm (8 of 46) [06/04/2000 13:03:52]