Siemens Hicom 150 E Office - Connecting a P 500 Printer

6.1.3 Connecting a P 500 printer
Caution
The safety and operating instructions provided by the printer manufacturer must be closely
observed.
Introduction
The P 500 dot-matrix printer can be implemented as a CDR printer (serial data transfer) or as the
output device of the call charge computer/manager (Hicom GCM) (parallel data transfer).
CDR printer
Figure 6-4 P 500 printer as CDR printer - connection and assignment
Procedure: Switch series settings on printer
Step Action
1. Remove printer cover
2. Remove ribbon cartridge
3. Remove cover (see Figure 6-5)
4. Select settings in accordance with Table 6-2 and Table 6-4
Hicom 150 E Office Rel.1.0 Service Manual - 6 Expanding the system
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6m.htm (9 of 14) [06/04/2000 13:05:06]