Siemens Hicom 150 E Office - DTMF Transmission During a Call

7.3 Features for general outgoing traffic
7.3.1 DTMF Transmission During a Call
Definition
You can activate the "DTMF transmission" feature while engaged in an internal or external call by
pressing a key or entering a code. From this point on, all keystrokes from the dialling keypad are
transmitted in the form of DTMF digits. If a call is placed to a port configured for voice mail from an
optiset E terminal, the connection automatically switches over to DTMF mode once it has been set up.
Alternatively, you can automatically switch over to DTMF mode after each successful connection
setup (even with CMI). The feature is configured system-wide (automatic DTMF).
Activating the transfer, enquiry, shuttle and call pickup features as well as answering a camped-on
call deactivates DTMF mode.
The DTMF characteristic (pulse/pause) can be configured in the system.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x _
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
DP extension DP extensions cannot use this feature.
Extension on hold An extension on hold cannot transmit any DTMF signals.
Conference, park, recall DTMF transmission cannot take place during a conference, recall or in
"park" mode.
Other features during DTMF When DTMF mode is active, you must always use the "S" key
(Service) to activate features during the call.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Hicom 150 E Office Rel.1.0 Service Manual - 7.3 Features for general outgoing traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_73.htm (1 of 6) [06/04/2000 13:10:06]