Siemens Hicom 150 E Office - Trunk Signalling Method

Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements Trunk board _
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
End-of-dialling time The longer the time for end of dialling, the longer it takes for the final digit to
be transmitted on an analog line.
Configuration options
The feature can be configured using:
Hicom Assistant E
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Modify end-of-dialling time
Options
2. System Parameters
3. Time parameters
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Dial an external number.
2. The last digit is only transmitted when the timer has elapsed.
7.6.9 Trunk Signalling Method
Definition
The signalling methods currently in use are:
Dial pulsing (DP) or
Dual-tone multifrequency signalling (DTMF)
In the case of DP, pulses are analysed, whereas DTMF analyses tones.
Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (11 of 21) [06/04/2000 13:10:46]