Siemens Hicom 150 E Office - Programming a Sensor as an Alarm Dialling Device

To Next Page

To Previous Page

8.23 Programming a sensor as an alarm dialling

device

Introduction

If you close an external contact (sensor) a signal is applied to a defined destination.

This destination can be an internal station, an internal group or an external telephone number.

Example

A message from sensor 1 is to be signalled at extension 12.

Programming with Hicom Assistant T

Step Entry Action Display

1. *95 31994 Start system administration System Administration

2. 27-1 Call up the Destination Number menu for the sensor (a

sensor can be directly selected with #)

Select Sensor 1:-

* 12

Define the destination number for the sensor Select Sensor 1: 12

4. F8-F7 Exit system administration Set time, Set date

Programming with Hicom Assistant E

Step Action

1. Options -> Trunk modules -> Sensors

Hicom 150 E Office Rel.1.0 Service Manual, 2, 1998-06-26

Siemens Part No.: P31003-M1530-X403-2-7620

Conversion Date: 1998-09-18

Hicom 150 E Office Rel.1.0 Service Manual - 8.23 Programming a sensor as an alarm dialling device

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_823.htm [06/04/2000 13:13:28]

Other manuals for Siemens Hicom 150 E Office