7.6.4 Extension Speed-Dialling in System
Definition
The user can create a separate speed-dialling list for frequently dialled numbers.
External numbers can be programmed in the database. Access is determined by the extension`s
dialling privileges. The route code must be entered prior to dialling the phone number.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Max. extension
speed-dialling entries per
extension
10 10 10 10
Max. length of extension
speed-dialling entry
25 Digits + Code 25 Digits+ Code 25 Digits+ Code 25 Digits+ Code
Max. no. of extension
speed-dialling entries in the
system
2000 2000 300 300
Dependencies/Limitations
Subject Dependency/Limitation
Terminals without display Following extension number entry, terminals without a display
must wait or the confirmation tone.
Analog terminals (with DP),
S
0
terminals
Extension speed-dialling is not possible
Internal extension numbers,
features
Internal extension numbers and features cannot be stored.
optiset E In the case of optiset E terminals, extension speed-dialling can
be stored under ten codes or under the terminal`s programmable
keys.
Repdial keys,
extension speed-dialling memory
Extension speed-dialling destinations can continue to be
assigned until the extension speed-dialling memory in the
system has been exhausted. The memory is used for both repdial
keys and extension speed-dialling destinations.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (5 of 21) [06/04/2000 13:10:45]
To Next Page
Loading...
