Siemens Hicom 150 E Office - Installation of Hicom 150 E Officecom, Officepoint, Officeone; Overview; Procedure for Installing Hicom 150 E Officecom, Officepoint

4.2 Installation of Hicom 150 E OfficeCom,
OfficePoint, OfficeOne
4.2.1 Overview
Chapter contents
This chapter discusses the following topics:
Installation of the Hicom 150 E OfficeCom, OfficePoint and OfficeOne communication
systems.
It describes the predominantly used installation procedures, information about supplementary
equipment and expansions can be found Section 6.2 and Chapter 10.
Configuration (board configuration).
Danger
The system must only be installed by authorised service personnel.
Tools and equipment required
The following items are required for the installation of the Hicom 150 E OfficeCom, OfficePoint,
OfficeOne systems:
Tools:
- Diagonal cutting pliers, telephone pliers, flat-nosed pliers
- Slotted screw drivers, from 2 to 8 mm
- Pozidriv cross-point screwdrivers, size 1 and 2
- Electric drill, hammer
- Level, metric rule
Equipment:
- Hicom Assistant T or Hicom Assistant E
- Digital multimeter for testing earth connections and partial voltage
- Hicom 150 E Office (electronic) Service Handbook
4.2.2 Procedure for installing Hicom 150 E OfficeCom, OfficePoint
Step Installation activity
1. Select the installation site (is generally already predefined)
2. Unpack the components
Hicom 150 E Office Rel.1.0 Service Manual -
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4fc.htm (1 of 9) [06/04/2000 13:04:51]