Siemens Hicom 150 E Office - Configuring an Entrance Telephone and Entrance Telephone Ring Destination

To Next Page

To Previous Page

8.21 Configuring an entrance telephone and

entrance telephone ring destination

Introduction

You can connect up to four entrance telephones to the system.

The telephones are usually connected to a free analog subscriber port.

One entrance telephone ring destination can be configured for each entrance telephone connected (the

entrance telephone ring destination configured can also be a group).

Example

Extension 250 is to be entrance telephone 1.

Extension 210 is to be the ring destination for entrance telephone 1.

Programming with Hicom Assistant T

Step Entry Action Display

1. *95 31994 Start system administration System Administration

2. 24-1 Select Doorphone CM 1 Door 1: -

* 250

Enter extension 250 Door 1: 250

4. F7 2 Select Doorbell CM 1 Door 1: -

* 210

Enter extension 210 Door 1: 210

6. F8 F7 Exit system administration Set time, Set date

Programming with Hicom Assistant E

Step Action

1. Options -> Trunk modules -> Ext. connection

Hicom 150 E Office Rel.1.0 Service Manual, 2, 1998-06-26

Siemens Part No.: P31003-M1530-X403-2-7620

Conversion Date: 1998-09-18

Hicom 150 E Office Rel.1.0 Service Manual - 8.21 Configuring an entrance telephone and entrance telephone ring destination

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_821.htm [06/04/2000 13:13:20]

Other manuals for Siemens Hicom 150 E Office