Siemens Hicom 150 E Office - Page 549

Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x _ _
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 _ _
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure CFW with rerouting
*9531994
2. 17-17-1 => Call Management Out - Route Optimise - Optimise Route
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure CFW with rerouting
Options
2. Lines / networking
3. Routing parameters
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. In an extension B in the satellite PABX, initiate CFW to an extension C in the main PABX.
2. Call extension B in the satellite PABX from an extension A in the main PABX.
3. The lines to the satellite PABX are released if possible.
Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (13 of 17) [06/04/2000 13:11:34]