Siemens Hicom 150 E Office - Page 631

17.
* 1
Enter route for rerouting Tab 1, Line 2: 1
18.
# 2
Dial route for digits that are not being
routed
Tab 2, Line 1: 0
19.
* 1
Enter route Tab 2, Line 1: 1
20. F7 Return to path tables Path tables
21. 2 Allocate the table to an outdial rule Tab 1, Line 1: 0
22.
* 1
Allocate to outdial rule 1 Tab 1, Line 1: 1
23. Confirm Next Tab 1, Line 2: 0
24.
* 2
Allocate to outdial rule 2 Tab 1, Line 2: 2
25.
# 2
Allocate table 2 to an outdial rule Tab 2, Line 1: 0
26.
* 2
Allocate to outdial rule 2 Tab 2, Line 1: 2
27. F7 Return to path tables Path tables
28. 5 Configure warning for rerouting Tab 1, Line 1: none
29. Confirm NEXT Tab 1, Line 2: none
30.
* 4
Warning: display and tone Tab 1, Line 1: Dsp/Tn
31. F7 Return to path tables Path tables
32. F7 Return to Least Cost Routing Least Cost Routing
33. 4 Enter authorisation code for DICS Index 1: -
34.
* 003
Enter carrier ID. Named by network
operation, e.g.: 003
Index 1: 003
35. Confirm Next Index 2: -
36.
* 12345
Enter customer ID. Named by
network operator, e.g. 12345
Index 2: 12345
37. F7 Return to Least Cost Routing Least Cost Routing
38. 3 Enter outdial rule Outdial rule
39. 1 Enter name Line 1: -
40.
* DICS
Enter name Line 1: DICS
41. Confirm Next Line 2: -
42.
* Telecom
Enter name Line 2: Telecom
43. F7 Return to outdial rule Outdial rule
Hicom 150 E Office Rel.1.0 Service Manual - 8.24 Configuring Least Cost Routing (DICS)
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_824.htm (2 of 3) [06/04/2000 13:13:33]