Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
General requirements Printer, Call charge computer
No. stored calls 300 150 50 50
Dependencies/Limitations
Subject Dependency/Limitation
PC/printer failure, buffer
full
If the connected device fails, some data records are buffered in the
system and transmitted when the device is reactivated. If the buffer is
full, all additional data records are lost.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure CDRC
*9531994
2. 11-3-1 => Call detail record - Print Format - Full/Compressed
3. 11-3-2 => Call detail record - Print Format - Digit Suppression
4. 11-3-3 => Call detail record - Print Format - Incoming Calls
5. 11-3-4 => Call detail record - Print Format - Call Duration
6. 11-3-5 => Call detail record - Print Format - Print MSN
7. Configure port for CDRC
22-13- 2-1 => 1 to 3 System Options - Charges/System
8. Set baud rate
22-13-1 => System Options - MB Baud Rate
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (12 of 21) [06/04/2000 13:08:18]
To Next Page
Loading...
