Siemens Hicom 150 E Office - Page 442

other extensions. These extensions may be in your own group or in a different group. This increases
the likelihood that incoming calls will always be answered.
With this feature, the call can be answered on an optiset E terminal by pressing a programmed and
flashing DSS key.
The following variants of the call pickup feature also exist:
Call Pickup (PU) Within Call Pickup Groups (on page 7-87)
Directed Call Pickup Outside a PU Group (on page 7-89)
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
PU with DSS key This procedure only enables you to pick up calls that are signalled as a ring.
Camp-on is not possible.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure DSS key
*91 => Entry to key programming.
2. Configure internal extension numbers via dialog box.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure DSS key
Options
2. Set up station
3. Key programming
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (39 of 48) [06/04/2000 13:09:59]