Answering and signalling initial calls and recalls.
Shuttle
Cancel enquiry
Pickup
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements U
P0/E
- terminals
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Max. number of call keys per optiset E
terminal
10 10 10 10
Dependencies/Limitations
Subject Dependency/Limitation
Routes,
busy state
The busy state is not displayed for the entire route.
Unscreened transfer, recall The call key is reassigned if the internal destination party is not reached
following unscreened transfer and a recall occurs.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure call key
*91 => Entry to key programming.
2. Press relevant key
3. Assign `Call key' to the selected key.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (6 of 10) [06/04/2000 13:10:14]
To Next Page
Loading...
