Siemens Hicom 150 E Office - Page 520

Opener: In this configuration, the door opener is set up via an a/b interface. In this case, the
entrance telephone must be connected via an adapter box.
DTMF: This setting determines whether the door opener is activated by a DTMF transmitter.
Call forwarding: This setting determines whether the call from the entrance telephone will be
forwarded to a forward by network destination from the destination extension.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available
in
x x x x
HW requirements Entrance telephone
or ET/A or
ET+amplifier
Entrance telephone
or ET/A or
ET+amplifier
Entrance telephone
or ET/A or
ET+amplifier
Entrance telephone
or ET/A or
ET+amplifier
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Max. number of
entrance
telephones
4 4 4 1
Dependencies/Limitations
Subject Dependency/Limitation
Entrance telephone ring
destination
If a call is already indicating camp-on at the entrance telephone ring
destination, an intercept is performed. If the intercept extension is
also busy, the system is scanned for optiset E terminals.
Night extension Night extension is not taken into account for signalling.
OfficeOne Door busy/service call available via optiset E Control Adapter
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Before setting up an entrance telephone, first delete all features for this extension.
2. *9531994
3. 24-1 => Doorphone Setup - Doorphone CM
4. 24-2 => Doorphone Setup - Doorbell CM
5. 24-3 => Doorphone Setup - Open door
6. 24-4 => Doorphone Setup - Doorphone forward
Hicom 150 E Office Rel.1.0 Service Manual - 7.8 Features for internal traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (6 of 17) [06/04/2000 13:11:10]