Dependencies/Limitations
Subject Dependency/Limitation
CDRC Only one CDRC exists for all subsystems.
Internal calls Internal calls can be made between extensions in "different" systems if
permitted by the traffic restriction group.
Prime Line Prime Line on can be configured only for the entire system.
CDBase printout Database printout is possible for the overall system only.
Internal directory All of the extension names and speed-dialling numbers in the system are
displayed.
Transfer Undialled lines cannot be transferred.
Simplified dialling Simplified dialling is not possible.
Speed transfer Speed transfer is not supported.
Intercept The intercept feature can only be programmed system-wide.
Tenant A maximum of three different tenants can be configured.
System configuration The system configuration can only be changed from a terminal (programming
device).
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Assign lines to extensions via TRG
* 9531994
2. 18-3-1-1 => Boss/Secretary - TRG groups - Group Setup -Ext
3. 18-3-1-2 => Boss/Secretary - TRG groups - Group Setup -Trk
4. 18-3-2-1 => Boss/Secretary - Connection groups - Conn group
5. Configure toll restriction for each tenant
15-1 => Trunk Access Day
6. 15-2 => Trunk Access Night
7. Delete intercept position
16-12 => Call Management Inc - Intercept, Day
8. 16-13 => Call Management Inc - Intercept, Night
9. Enter call allocation
16-16 => Call Management Inc - Non DID,Day
10. 16-17 => Call Management Inc - Non DID,Night
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_79.htm (3 of 5) [06/04/2000 13:11:17]
To Next Page
Loading...
