Siemens Hicom 150 E Office - Page 538

Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Set line type
*9531994
2. 17-14 => Call Management Out - Route Type
3. Set ISDN parameters
*9531994
4. 20-4 => ISDN Parameter Menu - EU parameters
5. Set trunk group codes
*9531994
6. 23-4 => Trunk Access Codes - Trunk Group Codes
7. 23-6 => Trunk Access Codes - Second Trunk Access Code
8. 35-1 => Least Cost Routing - Routing On/Off
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Set line type
Options
2. Lines / networking
3. Routing parameters
4. Set ISDN parameters
Options
5. Lines / networking
6. Trunks
7. Flags
8. Routes
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Call an extension in the other networked system.
Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (2 of 17) [06/04/2000 13:11:33]