0 in the Diversion/VPL tab. Deactivate Automatic line seizure in the Flags/CMI tab.
Switch to the Least cost routing window and activate Release LCR.
Make the following entries in the Dial plan window:
Line 1: Dialled digit 0CZ references route table 1 (plan for trunk call)
Line 2: Dialled digit 5-XX references route table 2 (plan for CorNet - extensions 500 - 599)
Line 3: Dialled digit 6-XX references route table 2 (plan for CorNet - extensions 600 - 699)
Line 4: Dialled digit 77CZ references route table 1 (plan for trunk call from slave system)
Make the the following entries in Route table 1 in the Route table window:
(table for trunk call)
Line 1: Route 1, Dial rule 1, Warning: NONE
Make the following entries in Route table 2 in the Route table window:
(table for CorNet call)
Line 1: Route 2, Dial rule 2, Warning: NONE
Make the following entries in the Dialling rules table:
Line 1: Rule name: Trunk, Rule format: A, Procedure: Main network supplier (rule for trunk call)
Line 2: Rule name: CorNet, Rule format: E1A, Procedure: Corporate network (rule for CorNet call)
Programming the slave system via Assistant E
Go to the Routes window in the Lines/networking menu and select route 1. Make the following
settings:
Enter the route name and set the 2nd trunk code to 0 (0 is the 1st trunk group code for route 1 in the
slave system).
The trunk group code for route 1 must be deleted.
The route type is set to PABX in the Routing parameters window and the route telephone number
(PABX number) is set under No. and type, outgoing.
In the Trunks window, double-click on the asterisk in the Param column for the relevant line to set
the protocol to S0: CorNet-N variant 2 slave (direct).
In the System Parameters window, ensure that the call number of the attendant code is deleted in the
Diversion/VPL tab. Deactivate Automatic line seizure in the Flags/CMI tab.
Switch to Least cost routing and activate Release LCR.
Make the following entries the in the Dial plan window:
Line 1: Dialled digit 0CZ references route table 1 (plan for trunk call)
Line 2: Dialled digit 1-XX references route table 2 (plan for CorNet - extensions 100 - 199)
Line 3: Dialled digit 2-XX reference route table 2 (plan for CorNet - extensions 200 - 299)
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_815.htm (4 of 13) [06/04/2000 13:12:59]
To Next Page
Loading...
