Incoming calls for the boss are only stored in the boss telephone's caller list; the secretary
cannot access this caller list.
All TOP members can check the status (call, busy, free) of the other TOP member on their
display by pressing the appropriate keys.
Different call signalling for boss calls (see System parameters "Tones and rings").
Only the secretary can camp-on at the boss telephone.
The boss telephone is not called during a system search.
Sample configuration of TOP system 1/1 with private line and second boss telephone
Call no. DID Name Terminal type
101 101 Boss Optiset E Memory
102 102 Secretary Optiset E Advance Plus + key module
103 103 Second boss telephone Analog telephone
The boss's private line should be assigned the call number 666.
Configuring the Enhanced TOP variant:
1. Configure the additionally required analog ports for call signalling:
Call no. DID Name Terminal type
108 -- Boss Analog port (POT)
109 -- Secretary Analog port (POT)
The analog ports must be actively connected!
2. Configure boss/secretary group 1 (see also Section 8.20):
In Assistant E via "Incoming Calls - Boss/Sec. Group".
In Assistant T via "Boss/secretary - Boss/Secretary Grp" (18-1):
101 (boss 1)
103 (boss 2)
102 (secretary 1)
3. Set up group calls:
Call no. DID Name Type Members
351 -- Boss No answer 102, 101
666 666 Private line No answer NONE
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_817.htm (2 of 5) [06/04/2000 13:13:09]
To Next Page
Loading...
