Broadcast Pix BPswitch - Page 400

BPswitch Operators Manual
400 / 413
2.
In the address bar, enter the external
IP address of the remote Broadcast
Pix system. In most causes this is
not the assigned IP address on the
Server NIC card. If the external IP
address is not known, on the
Broadcast Pix Server go to
www.whatsmyip.com.
Your IP address will be displayed in
the web browser, for example
67.152.12.226.
Enter that IP address followed by the
Web Server Port number assigned,
for example:
http://67.152.12.226:26000/Browse
rControl/softpanel1000.aspx
It is important to add the colon :
between the IP address and Web
Server Port. This will open a 1ME
SoftPanel. You can also just type in
the IP address and it will go to the
launcher page where you can select
the SoftPanel. Log in may be
required. Contact your administrator
if you do not have log in credentials.
3.
Click on return on the keyboard to
launch the SoftPanel in the web
browser.
4.
If at any time the SoftPanel loses
connection to the main Server, you
can click Reload in your web
browser to attempt to reconnect if
the switcher is running.
To control a remote system with a Control Panel:
Note that the physical control panel does not have
buttons labels, use the labels below as a reference.
1.
Make sure the control is if Offline, by
closing the BPswitcher application.
2.
The 3 wildcard device buttons in the Device