EasyManua.ls Logo

Broadcom BCM5722 - Table 397: NVM Write Register (Offset 0 X7008); Table 398: NVM Address Register (Offset 0 X700 C); Table 399: NVM Read Register (Offset 0 X7010)

Broadcom BCM5722
593 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BCM5722 Programmer’s Guide
10/15/07
Broadcom Corporation
Page 371 Non-Volatile Memory Interface Registers Document 5722-PG101-R
NVM WRITE REGISTER (OFFSET 0X7008)
NVM ADDRESS REGISTER (OFFSET 0X700C)
NVM READ REGISTER (OFFSET 0X7010)
Table 397: NVM Write Register (Offset 0x7008)
Bit Field Description Init Access
31:0 wrdata 32 bits of write data are used when write commands are executed.
For BCM5787, BCM5787M, BCM5754, and BCM5754M, when
bitbang_mode is set, bits 0 to 3 control the drive value of the SCK,
CS_L, SO, and SI pins respectively.
For BCM5722, BCM5755, BCM5755M, BCM5756M, BCM5757 in a
144-pin FBGA package, when bitbang_mode is set, bits 0 to 5 control
the drive value of the SCL, SDA, SDK, CS_L, SO, and SI pins
respectively. For a 100-pin FBGA package, the EECLK and EEDATA
share with SCK and SO.
0 R/W
Table 398: NVM Address Register (Offset 0x700C)
Bit Field Description Init Access
31:24 Reserved 0 RO
23:0 wraddr 24-bit address value.
For BCM5787, BCM5787M, BCM5754, and BCM5754M,
when bitbang_mode is set, bits 0 to 3 control the OE value of
the SCK, CS_L, SO, and SI pins respectively. Note that SCL,
SDA, and SI are active high, and SCK, CS_L and SO are
active low.
For BCM5722, BCM5755, BCM5755M, BCM5756M,
BCM5757 in a 144-pin FBGA package, when bitbang_mode
is set, bits 0 to 5 control the OE value of the SCL, SDA, SDK,
CS_L, SO, and SI pins respectively. For a 100-pin FBGA
package, the EECLK and EEDATA share with SCK and SO.
SCL and SDA are active high, and SCK, CS_L, SO, and SI
are active low.
0 R/W
Table 399: NVM Read Register (Offset 0x7010)
Bit Field Description Init Access
31:0 rddata 32 bits of read data are used when read commands are executed.
For BCM5787, BCM5787M, BCM5754, and BCM5754M, when
bitbang_mode is set, bits 0 to 3 reflect the current input value of the
SCK, CS_L, SO, and SI pins, respectively.
For BCM5722, BCM5755, BCM5755M, BCM5756M, BCM5757 in a
144-pin FBGA package, when bitbang_mode is set, bits 0 to 5 control
the OE value of the SCL, SDA, SDK, CS_L, SO, and SI pins
respectively. For a 100-pin FBGA package, the EECLK and EEDATA
share with SCK and SO.
0R/W

Table of Contents