T129: Drive Sled Firmware Image Error
Description GUI Description: Drive sled firmware cannot be auto-leveled due to a
missing or corrupt drive sled firmware image.
Explanation: During an attempt to autolevel the drive sleds, the library
detected a missing or corrupt UDS.lif (drive sled firmware) file.
Detection Scenario Main Library Firmware that controls and performs drive sled firmware
updates detects that the drive sled firmware update file is missing or
corrupted.
Root Causes The drive sled firmware update file is missing or corrupted.
Possible FRUs Library firmware
Resolution Perform “DR095: Resolve Drive Sled Auto-level Failure” on page 6-89.
T130: Tape Drive Cleaning Failure
Description GUI Description: A tape drive was cleaned but continues to request cleaning.
Explanation: After a drive was cleaned and the cleaning tape was removed
from the drive, the drive continues to request cleaning.
Detection Scenario A drive continues to request cleaning after successful cleaning cycles have
been applied.
Root Causes Tape drive malfunction.
Possible CRUs Drive Sled.
Resolution Perform “DR096: Resolve Drive Cleaning Failure” on page 6-89.
T132: Hardware Clock Failure
Description GUI Description: The hardware real-time clock (RTC) has failed. The library
system time may appear to be set correctly, but accurate time will be lost
following a power cycle or reboot.
Explanation: While setting the library time, the library detected an error in
the hardware real-time clock (RTC). This type of error will allow the library
system time to be changed, but the time will not be set correctly following a
power cycle or reboot.
Detection Scenario Main library firmware determined that setting the hardware clock failed,
though the system time may appear to have been set correctly.
Root Cause The hardware clock on the LCB has failed.
Possible CRUs LCB
Resolution Perform “DR098: Resolve Hardware Clock Failure” on page 6-89.
T133: Barcode Label Mapping Failure
Description GUI Description: The library control firmware cannot map barcode labels to
respective slots during an inventory operation.
Explanation: The library is attempting to map barcode labels during
inventory and is being prevented from doing so because one or more
barcode labels are improperly attached, or a magazine is improperly
seated/installed.
Chapter 6. Service Action Tickets (Txxx) and Diagnostic Resolutions (DRxxx) 6-53
To Next Page
Loading...
Need help?
General
