Class I Laser Product
The library may contain a laser assembly that complies with the performance
standards set by the U.S. Food and Drug Administration for a Class I laser
product. Class I laser products do not emit hazardous laser radiation. The library
has the necessary protective housing and scanning safeguards to ensure that laser
radiation is inaccessible during operation or is within Class I limits. External safety
agencies have reviewed the library and have obtained approvals to the latest
standards as they apply.
Protective Devices
The library has the following protective devices:
v Monitored access to the library
v Main power switch
Monitored Access to the Library
The library is completely surrounded by an enclosure. The library can be accessed
only from monitored access areas.
The enclosure around the library separates the danger area of the library from the
working area. The danger area is the area in which personnel can be injured by
component movements.
CAUTION:
Movements of mechanical components in the library can cause serious
injury. Access to the library should be restricted to authorized
personnel only.
Main Power Switch
To turn library power ON, press | on each power switch installed in the library. To
turn library power OFF, press 0 on the switch. In any case of danger, immediately
turn the main power switch of the library OFF.
CAUTION:
To completely remove all power, disconnect the power cord from the
electrical outlet.
Attention: Except in emergencies, stop the library with the normal shutdown
procedure before you switch OFF the main power switch. IBM is not responsible
for damage caused by improper use of the main power switch. Such risk lies
entirely with the user.
CAUTION:
Movements of mechanical components in the tape library can cause
serious injury. Before turning the main power switch ON and
restarting the tape library, confirm that no danger exists to personnel
or property.
Chapter 5. Safety and Environmental Notices 5-3
To Next Page
Loading...
Need help?
General
