IBM TS3310 User Manual

2. Press the Unload Button once per second until
9
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
view the most recent error code.
4. Press the Unload Button again to view successive error codes. Let two to three
seconds pass between each depression. The SCD will display
0
when all the
error codes have been displayed.
5. After viewing all error codes, exit this function by pressing the Unload Button
again. The SCD will display
0
and exit Maintenance Mode.
Function Code A: Clear Error Code Log
Function Code
A
erases the contents of the error code log.
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page D-27.
2. Press the Unload Button once per second until
A
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
select the function.
A
flashes in the SCD, followed by
0
. The tape drive
erases all errors from the error code log and exits Maintenance Mode.
Function Code C: Insert Cartridge into Tape Drive
This function cannot be selected by itself, but is part of other maintenance
functions (such as Run Tape Drive Diagnostics and Create FMR Tape) that require
a tape cartridge to be inserted.
Function Code E: Test Cartridge & Media
Approximate Run Time = 15 minutes per loop
Total Number of Loops = 10
Function Code
E
performs tests that determine whether a suspect cartridge and
its magnetic tape are acceptable.
Press the Unload Button to stop the diagnostic and exit maintenance mode.
Pressing the Unload Button once will abort the test at the end of the current test
loop. Pressing the Unload Button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
Attention: When you perform this test, data on the suspect tape will be
overwritten.
Appendix D. Using Ultrium Drives D-35

IBM TS3310 Specifications

General

Form Factor	Rack-mountable
Tape Technology	LTO Ultrium
Product Type	Tape Library
Interface	Fibre Channel
Expansion	Expandable with additional modules
Supported Tape Technology	LTO Ultrium 5, LTO Ultrium 6
Weight	120 lb (54.4 kg) (fully configured)
Power Supply	Dual redundant power supplies
Operating Temperature	41°F to 95°F (5°C to 35°C)
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)
Humidity	20% to 80% non-condensing