EasyManuals Logo

IBM TS3310 User Manual

IBM TS3310
531 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #209 background imageLoading...
Page #209 background image
v Network settings:
IP Address
Subnet Mask & Gateway addresses
v Feature Code licenses keys
v Logical library configuration
v Cartridge slot assignments
v Cleaning slot configuration
v I/O Station configuration
v Drive IDs:
SCSI ID
Fibre Loop ID
SAS ID
v Encryption method selections
v Administrator and user account information
Key Path Diagnostics
From the Web User Interface: Service Library Key Path Diagnostics
An Encryption Key path diagnostic function is provided to assist the
Administrative user in the setup, configuration, or troubleshooting of Library
Managed Encryption (LME) enabled libraries. This diagnostic consists of four tests:
1. Drive Test This is a drive communication test to ensure that the Library-Drive
Interface (LDI) is functioning properly.
2. Ethernet Test This is a key server ‘ping' test of all IP addresses associated
with LME configured drives.
3. Key Path Diagnostic This is a communication test used to establish a link to a
key manager and ensure that the communication paths between each drive and
the EKM have been correctly installed and setup.
4. EKM Config Test This is a final test to establish a link to a key manager and
request a default key. This ensures that the drive has been correctly configured
in the EKM to service key requests.
To execute Key Path Diagnostics, from the web UI, go to Service Library Key
Path Diagnostics and click Start Tests.
These tests are run sequentially on each IP address of each drive that is enabled for
LME. If a particular test fails, the subsequent tests for that same IP address are not
run, and the results will show N/A.
Note: The diagnostics tests may take several minutes to complete. To run any of
the tests, the tape drive used for the test must be unloaded, ready, and
online.
If any of the tests fail, try the following resolutions and run the test again to make
sure it passes:
v Ping Test Failure - Verify that the key server host is running and accessible from
the network the library is on.
Chapter 7. Service Procedures 7-13
|
|
|
|
|
|
|
|
|
|

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM TS3310 and is the answer not in the manual?

IBM TS3310 Specifications

General IconGeneral
Form FactorRack-mountable
Tape TechnologyLTO Ultrium
Product TypeTape Library
InterfaceFibre Channel
ExpansionExpandable with additional modules
Supported Tape TechnologyLTO Ultrium 5, LTO Ultrium 6
Weight120 lb (54.4 kg) (fully configured)
Power SupplyDual redundant power supplies
Operating Temperature41°F to 95°F (5°C to 35°C)
Non-operating Temperature-40°F to 140°F (-40°C to 60°C)
Humidity20% to 80% non-condensing

Related product manuals