-SCS Parameter Analyzer Reference Manual Section 13:
LPT library function reference
4200A-901-01 Rev. C / February 2017 13-211
Code Status or error titles
I-limit value %g too small for specified range.
I-limit value %g too large for specified range.
I-range value %g too large for specified range.
V-limit value %g too large for specified range.
V-range value %g too large for specified range.
Value too big for range selection, %g.
Safe operating area for device exceeded.
Thermal shutdown has occurred on device %s.
Limit value %g too large for specified range.
V-limit value %g too small for specified range.
Range too small for force value.
Cannot force when not connected.
C-range value %g too large for specified range.
G-range value %g too large for specified range.
VMTR not allocated to make the measurement.
Timeout occurred attempting measurement.
Power Limited to 20 W. Check voltage and current range settings.
IEEE-488 time out during data transfer for addr %d.
No IEEE-488 interface in configuration.
IEEE-488 secondary address %d invalid for device.
IEEE-488 invalid primary address: %d.
IEEE-488 receive buffer overflow for address %d.
No SMU found, kelvin connection test not performed.
DMM not connected to SRU.
GPIB communication problem.
SRU not mechanically calibrated.
SRU kelvin connection problem.
Floating point divide by zero.
Floating point log of zero or negative number.
Floating point square root of negative number.
Floating point pwr of negative number.
PCI ID read back on send error, slot.
Protocol version mismatch.
-510
No command byte available (read) or SRQ not asserted.
To Next Page
Loading...
