Step Action
1. Configure actuators
* 9531994
2. 26-1 => Actuator Setup - Type
3. 26-2 => Actuator Setup - React time
4. 26-3 => Actuator Setup - Assigned ext
5. 26-4 => Actuator Setup - Actuator name
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure actuators
Options
2. Trunk modules
3. Actors
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Configure an actuator.
2. Select the code for the actuator.
3. The actuator reacts according to the configuration.
7.10.4 Sensors
Definition
Control inputs (sensors) can be implemented in Hicom 150 E Office via an optional control relay
module. When responding to a sensor, the station assigned receives an automatic call. When the
station replies, an appropriate text can be played by an announcement device. The signal input
function is triggered by closing any external, floating working contact. The electrical isolation
between the external circuit and system control is performed by an optocoupler.
The sensors can trigger the following functions:
Call signalling at telephones
Display message at optiset E telephones
Evaluation of the start/stop signal of an announcement device
Answering machine control
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_710.htm (5 of 19) [06/04/2000 13:07:30]
To Next Page
Loading...
