7.1.10 Recall
Definition
A held call that is not answered, or a call that was not switched successfully is signalled at the
initiating extension as a recall. Either the number of the switched internal or external extension or the
number of the destination extension is displayed on the initiating party`s screen.
An automatic recall is always carried out if:
1. a call was parked for a certain period of time or was placed on common hold and was not
answered. The recall takes place upon expiry of the hold/park timer (recall a parked connection).
2. an unscreened transfer was carried out to a party who did not answer the call within a certain
period of time (recall a transferred/switched line).
3. an unscreened transfer was carried out to an extension and the destination does not exist, is busy
with a second call or the terminal is defective (in the case of digital terminals) or the transfer type
was not allowed (transfer external call to external destination). In this case, an immediate recall is
carried out.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
This feature does not have to be explicitly configured.
Programming Feature Via Hicom Assistant E
Although this feature does not have to be explicitly configured, you can configure the recall time via
Hicom Assistant E:
Step Action
1. Configure recall time
Options
2. System Parameters
3. Time parameters
4. Dial time during transfer before answer
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_71.htm (11 of 18) [06/04/2000 13:09:16]
To Next Page
Loading...
