Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure directory
*9531994
2. 22-12 => System Options - Phonebook
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure directory
Options
2. System Parameters
3. Flags / CMI
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Lift the handset on an optiset E terminal with display. `Directory?' appears on the display.
2. Confirm your selection.
7.8.11 Babyphone (Room Monitor)
Definition
The "Babyphone" feature can be used for monitoring a room. All terminal types can be used for this
purpose. Room monitoring can be executed from internal extensions.
When monitoring is activated, the terminal used as a room monitor does not receive call signalling,
i.e. the call is switched through immediately.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (16 of 17) [06/04/2000 13:11:11]
To Next Page
Loading...
