11.
# 2
Select 2nd UCD group and confirm Grp 2, Mbr 1: Device 1
12. *3 Assign Announcement device 3 Grp 2, Mbr 1: Device 3
13.
*4
Assign Announcement device 4 Grp 2, Mbr 2: Device 4
14. F7 Return to Group Options submenu 313 Group Options
Group Options - queue timers (31 2 2)
Each queue device (total of 7 per UCD group) has its own queue timer
(1-20).
Default queue time entry: 1 = 30s, maximum: 20 = 6 min
Note: no times should be programmed for announcements.
Programming with Hicom Assistant T
Step Entry Action Display
1. 31-2-2 Change queue timers (1st UCD group) Grp 1, Mbr 1: 1
2.
Scroll to 2nd Mbr (1st UCD group) Grp 1, Mbr 2: 1
3.
*2
Enter 2 (=60s) Grp 1, Mbr 2: 2
4.
#2
Change queue timers (2nd UCD group) Grp 2, Mbr 1: 1
5.
*3
Scroll to 2nd Mbr (2nd UCD group) 3=90s and confirm Grp 1, Mbr 2: 3
6. F7 Return to Group Options submenu 313 Group Options
Group Options - call cycles (31 2 3)
The call cycles are set under Group Options.
A distinction is made between primary and secondary cycles and the call cycle in Call
Management.
The call cycles in Call Management are changed accordingly.
Programming with Hicom Assistant T
Step Entry Action Display
1. 31-2-3 Select UCD group and change call cycles Call cycles
2. 1 Change to Primary cycle Grp 1: 3
3.
*4
Change the primary cycle Grp 1: 4
4.
*5
Scroll to 2nd UCD group and change the default value Grp 2: 5
Hicom 150 E Office Rel.1.0 Service Manual - 8.31 UCD - Universal Call Distribution
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_831.htm (4 of 7) [06/04/2000 13:14:19]
To Next Page
Loading...
