delay clear (T3/E3)
To configure the amount of time before a T3 or E3 path delay trigger alarm is cleared, use the delay clear
command in T3 or E3 configuration mode. To return the command to its default setting, use the no form of
this command.
delay clear value
no delay clear value
Syntax Description
Value, in milliseconds, before a T3 or E3 path delay trigger alarm is cleared. The range
is from 0 through 180000. The default is 10 seconds.
value
Command Default
The default is 10 seconds.
Command Modes
T3 configuration
E3 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Support for E3 configuration mode was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify that T3 path delay trigger alarms should be cleared after 9000
seconds:
RP/0/RSP0/CPU0:router(config)# controller t3 0/4/2/0/1
RP/0/RSP0/CPU0:router(config-t3)# delay clear 9000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
980
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
delay clear (T3/E3)
To Next Page
Loading...
Need help?
General
