invert
To invert the data stream on a serial interface, use the invert command in serial configuration mode. To disable
data inversion, use the no form of this command.
invert
no invert
Syntax Description
This command has no keywords or arguments.
Command Default
Data is not inverted.
Command Modes
Serial configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To verify that data inversion is configured on the interface, use the show interfaces serial command.
Task ID
OperationsTask ID
read, writehdlc
Examples
In the following example, data inversion is enabled on serial interface 0/3/0/0/0:10:
RP/0/RSP0/CPU0:router(config)# interface serial 0/3/0/0/0:10
RP/0/RSP0/CPU0:router(config-if)# serial
RP/0/RSP0/CPU0:router(config-if-serial)# invert
Related Commands
DescriptionCommand
Displays statistics for all interfaces configured on the router or for
a specific node.
show interfaces, on page 516
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
790
Serial Interface Commands on the Cisco ASR 9000 Series Router
invert
To Next Page
Loading...
Need help?
General
