show ppp sso alerts
To display all Inter-Chassis Stateful Switchover (ICSSO) alerts that have occurred, use the show ppp sso
alerts command in EXEC mode.
show ppp sso alerts location node-id
Syntax Description
Specifies the full qualified path of a specific node in the format
rack/slot/module.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command displays the following information for alerts that have prevented a standby session from being
brought to the Standby-Up state using replicated data.
•
The interfaces on which the alerts have occurred
•
The layer in which the error has occurred
•
A short description of the error
Only one error is reported for each layer for each interface. The error displayed is the most recent error
that has occurred.
Note
Task ID
OperationsTask ID
readppp
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
765
PPP Commands onthe Cisco ASR 9000 Series Router
show ppp sso alerts
To Next Page
Loading...
Need help?
General
