b3-ber-prdi
To enable sending of a path-level remote defect indication (PRDI) when the bit error rate (BER) bit interleaved
parity (BIP) B3 threshold is exceeded, use the b3-ber-prdi command in SONET/SDH path configuration
mode. To disable sending a PRDI, use the no form of this command.
b3-ber-prdi
no b3-ber-prdi
Syntax Description
This command has no keywords or arguments.
Command Default
This command is disabled by default; a PRDI is not sent.
Command Modes
SONET/SDH path configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows a PRDI enabled on all paths:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/2/0/2
RP/0/RSP0/CPU0:router(config-sonet)# path
RP/0/RSP0/CPU0:router(config-sonet-path)# b3-ber-prdi
Related Commands
DescriptionCommand
Enters SONET/SDH path configuration mode.path (SONET), on page 884
Displays information about the operational status of SONET
layers.
show controllers sonet, on page 906
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
848
SONET Controller Commands on the Cisco ASR 9000 Series Router
b3-ber-prdi
To Next Page
Loading...
Need help?
General
