Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to disable link-monitoring on an Ethernet OAM interface:
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# monitoring disable
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration
mode.
ethernet oam profile, on page 215
Enables Ethernet Link OAM, with default values, on an interface
and enter interface Ethernet OAM configuration mode.
ethernet oam, on page 212
Enters Ethernet OAM link monitor configuration mode.link-monitor, on page 262
Attaches an Ethernet OAM profile to an interface.profile (EOAM), on page 299
Displays the current active Ethernet OAM configuration on an
interface.
show ethernet oam configuration, on page
366
Displays the local and remote Ethernet OAM statistics for
interfaces.
show ethernet oam statistics, on page 377
Displays the current state of Ethernet OAM interfaces.show ethernet oam interfaces, on page 374
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
288
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
monitoring

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model