Cisco ASR 9000 Series Command Reference Guide

DescriptionField
Average number of bits and
packets received per second in the
last 5 minutes. If the interface is
not in promiscuous mode, it senses
network traffic that it sends and
receives (rather than all network
traffic).
The 5-minute period
referenced in the
command output is a load
interval that is
configurable under the
interface. The default
value is 5 minutes.
Note
The 5-minute input should
be used only as an
approximation of traffic
per second during a given
5-minute period. This rate
is exponentially weighted
average with a time
constant of 5 minutes. A
period of four time
constants must pass before
the average will be within
two percent of the
instantaneous rate of a
uniform stream of traffic
over that period.
Note
5 minute input rate
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
525
Global Interface Commandsonthe Cisco ASR 9000 Series Router
show interfaces

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model