Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

DescriptionField
The number of links on the device (from 0 to the
maximum number of supported links for the bundle)
in the format
x / y / z, with the following values:
• x—Number of links in Active state on the
bundle.
• y—Number of links in Standby state on the
bundle.
• z—Total number of links configured on the
bundle.
Local links <active/standby/configured>:
Bandwidth characteristics on the bundle in kilobits
per second (kbps) in the format x / y, with the
following values:
• x—Current bandwidth of the bundle (this
effective bandwidth might be limited by
configuration).
• y—Available bandwidth of the bundle that is
the sum of the bandwidths of all of the locally
active links.
Local bandwidth <effective/available>:
Layer 2 MAC address on the bundle interface in the
format
xxxx.xxxx.xxxx. The (source) of the address
is shown in parentheses with the following possible
values:
• Interface name—The MAC address is from the
displayed member interface type and path.
• Configured—The MAC address is explicity
configured.
• Chassis pool—The MAC address is from the
available pool of addresses for the chassis.
• [unknown MAC source 0]—No MAC address
could be assigned to the bundle. (You might see
this display if you have not completed your
bundle configuration.)
MAC address (source):
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
622
Link Bundling Commands on the Cisco ASR 9000 Series Router
show bundle