Cisco ASR 9000 Series Command Reference Guide

Syntax Description
(Optional) Configures the priority
of outgoing SLA probe packets.
The range is 0 to 7. The default is
to use the COS bits for the egress
interface.
priority number
(Optional) Sends one packet one
time.
send packet once
(Optional) Sends one packet every
specified number of milliseconds,
seconds, minutes, or hours, where
number is in the following range:
•
1 to 3600 seconds
•
1 to 1440 minutes
•
1 to 168 hours
•
100 to 10000 milliseconds
(specified in increments of
100)
send packet every number {milliseconds | seconds | minutes | hours}
(Optional) Specifies that a burst of
packets is sent one time. This is the
default.
send burst once
(Optional) Sends a burst of packets
every specified number of seconds,
minutes, or hours, where number
is in the following range:
• 1–3600 seconds
• 1–1440 minutes
• 1–168 hours
The default is to send a burst every
10 seconds.
send burst every number {seconds | minutes | hours}}
Specifies the number of packets to
be sent in a burst, in the range 2 to
600. The default is 10.
packet count number
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
225
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-delay-measurement probe

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model