show monitor-session counters
To display statistics regarding traffic mirroring sessions, use the show monitor-session counters command
in EXEC mode.
show monitor-session [ session-name ] counters
Syntax Description
Name of the monitor session to configure.
session-name
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The show monitor-sessions counters command displays a list of all source interfaces, and the replicated
packet statistics for each interface. The full set of statistics displayed for each interface is:
•
Ingress replicated packets and octets
•
Egress replicated packets and octets
•
Non-replicated packets and octets
Examples
This example shows sample output from the show monitor-session counters command:
RP/0/RSP0/CPU0:router show monitor-session 2 counters
Monitor session 2
GigabitEthernet 0/3/0/0.100:
Rx Replicated: 100 Packets 8000 Bytes
Tx Replicated: 2 Packets 3000 Bytes
Non Replicated: 0 Packets 0 Bytes
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1088
Traffic Mirroring Commands on the Cisco ASR 9000 Series Router
show monitor-session counters
To Next Page
Loading...
