ethernet uni id
To specify a name for the Ethernet User-Network Interface (UNI) link, use the ethernet uni id command in
interface configuration mode.
ethernet uni id name
Syntax Description
Maximum of 64 characters to identify the Ethernet UNI link.
name
Command Default
No name is specified for the Ethernet UNI link.
Command Modes
Interface (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The UNI name should be unique among all UNIs that are part of a given Ethernet Virtual Connection (EVC).
When the Ethernet Local Management Interface (E-LMI) protocol is running on the UNI, the name specified
in the ethernet uni id command is advertised by E-LMI to the Customer Edge (CE) device. It is also carried
in Ethernet Connectivity Fault Management (CFM) Continuity Check Messages (CCMs) if there is an Up
MEP on the UNI, and passed to E-LMI on the peer MEP so that it can be advertised to the remote CE device.
Task ID
OperationTask ID
read, writeinterface
Examples
The following example shows how to configure the UNI name called "PE1-CustA-Slot0-Port0" on Gigabit
Ethernet interface 0/0/0/0:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/0/0/0
RP/0/RSP0/CPU0:router(config-if)# ethernet uni id PE1-CustA-Slot0-Port0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
245
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet uni id
To Next Page
Loading...
Need help?
General
