Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to configure the low and high thresholds that trigger a frame-seconds error
event:
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor (config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame-seconds threshold low 10 high 900
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration
mode.
ethernet oam profile, on page 215
Enters Ethernet OAM link monitor configuration mode.link-monitor, on page 262
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
253
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame-seconds threshold

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model