ppp multilink multiclass remote apply
To configure the minimum number of Multiclass Multilink PPP (MCMP) receive classes that a local host will
accept from its peer in a Conf-Request, use the ppp multilink multiclass command in interface configuration
mode. To remove this setting, use the no form of this command.
ppp multilink multiclass remote apply min-number
no ppp multilink multiclass remote apply min-number
Syntax Description
Specifies the minimum number of receive classes in the Conf-Request. The
range is 1 to 16.
min-number
Command Default
The default is 2 if MCMP is enabled.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command is used to coerce the peer to accept a minimum number of MCMP classes. If the peer does not
accept the minimum number of MCMP classes specified by this command, the local router will not bring up
the PPP link.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to use the ppp multilink multicast remove apply command.
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface Multilink 0/1/0/0/1
RP/0/RSP0/CPU0:router(config-if)# ppp multilink multiclass remote apply 16
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
746
PPP Commands onthe Cisco ASR 9000 Series Router
ppp multilink multiclass remote apply
To Next Page
Loading...
Need help?
General
