Cisco ASR 9000 Series - Uneq-Shut (SONET Path)

uneq-shut (SONET path)
To enable automatic insertion of P-UNEQ code (0x00) in the sent SONET path overhead C2 byte, use the
uneq-shut command in SONET/SDH path configuration mode. To disable this feature, use the no form of
this command.
uneq-shut
no uneq-shut
Syntax Description
This command has no keywords or arguments.
Command Default
Automatic insertion is enabled.
Command Modes
SONET/SDH path configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the uneq-shut command to disable automatic insertion of P-UNEQ code in the sent SONET path overhead
C2 byte whenever the SONET path enters the administratively down state.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
In the following example, automatic insertion of P-UNEQ code is disabled in the sent SONET path overhead
C2 byte:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/2/0/2
RP/0/RSP0/CPU0:router(config-sonet)# path
RP/0/RSP0/CPU0:router(config-sonet-path)# uneq-shut
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
929
SONET Controller Commands on the Cisco ASR 9000 Series Router
uneq-shut (SONET path)