pvc (frame relay)
To associate a data-link connection identifier (DLCI) number to a permanent virtual circuit (PVC), and to
enter Frame Relay PVC configuration mode, use the pvc command in subinterface configuration mode. To
delete the PVC, use the no form of this command.
pvc dlci-number
no pvc dlci-number
Syntax Description
DLCI number used to identify the PVC. The range is from 16 to 1007.
dlci-number
Command Default
No PVC is defined.
Command Modes
Subinterface configuration (config-subif)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Commands available in Frame Relay PVC configuration mode are:
RP/0/RSP0/CPU0:router(config-fr-vc)# ?
commit Commit the configuration changes to running
describe Describe a command without taking real actions
do Run an exec command
encap Set the Encapsulation of this PVC
exit Exit from this submode
no Negate a command or set its defaults
show Show contents of configuration
The pvc command is available on Packet-over-SONET/SDH (POS), serial, and multilink interfaces.
Task ID
OperationsTask ID
read, writefr
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
460
Frame Relay Commands on the Cisco ASR 9000 Series Router
pvc (frame relay)
To Next Page
Loading...
Need help?
General
