Cisco ASR 9000 Series Command Reference Guide

g709 otu overhead tti
To configure the OTU Trail Trace Identifier (TTI) buffer for a DWDM controller, use the g709 otu overhead
tti command in DWDM configuration mode. To return to the default state, use the no form of this command.
g709 otu overhead tti {expected| sent} {ascii| hex} tti-string
no g709 otu overhead tti {expected| sent} {ascii| hex} tti-string
Syntax Description
Configures the expected TTI string.expected
Configures the transmit TTI string.sent
Indicates that the string is in ASCII format.ascii
Indicates that the string is in hexidecimal format.hex
The TTI string. A maximum of 64 characters is allowed.tti-string
Command Default
No TTI string is configured
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display the TTI strings, use the show controller dwdm g709 command.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
15
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 otu overhead tti

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model