show ppp sso state
To display the Inter-Chassis Stateful Switchover (ICSSO) states of a Point-to-Point Protocol (PPP) session
running under a particular Multi-Router Automatic Protection Switching (MR-APS) group, use the show ppp
sso state command in EXEC mode.
show ppp sso state group group-id location node-id
Syntax Description
Specifies the redundancy group number. The range is 1 to 32.
group group-id
Specifies the full qualified path of a specific node in the format
rack/slot/module.
location node-id
Command Default
If group is not specified, states are displayed for all redundancy groups.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command shows the states of these session layers:
•
LCP
•
of-us authentication
•
of-peer authentication
•
IPCP
When an interface is in Standby mode, it is ready to forward traffic immediately after a switchover, if all
the session layers, including IPCP, are in the S-Negd state.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
767
PPP Commands onthe Cisco ASR 9000 Series Router
show ppp sso state
To Next Page
Loading...
Need help?
General
