feedback disable
To disable the IP header compression (IPHC) context status feedback messages on an interface, use the
feedback disable command in IPHC profile configuration mode. To re-enable feedback messages after they
are disabled, use the no form of this command.
feedback disable
no feedback disable
Syntax Description
This command has no keywords or arguments.
Command Default
Feedback messages are enabled by default.
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Feedback disable can be configured only within an IPHC profile.Note
Task ID
OperationsTask ID
read, writeip-services
Examples
The following example shows how to disable the IP header compression (IPHC) context status feedback
messages within an IPHC profile:
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# iphc profile Profile_1 type iphc
RP/0/RSP0/CPU0:router(config-iphc-profile)# feedback disable
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
784
Serial Interface Commands on the Cisco ASR 9000 Series Router
feedback disable
To Next Page
Loading...
Need help?
General
