Cisco ASR 9000 Series - Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router

Dense Wavelength Division Multiplexing
Commands on the Cisco ASR 9000 Series Router
This module provides command line interface (CLI) commands for configuring dense wavelength division
multiplexing (DWDM) on the Cisco ASR 9000 Series Router.
•
admin-state, page 3
•
controller dwdm, page 5
•
g709 bdi-to-client-gais, page 7
•
g709 enable, page 8
•
g709 fec, page 9
•
g709 odu overhead tti , page 11
•
g709 odu report disable, page 13
•
g709 otu overhead tti, page 15
•
g709 otu report disable, page 17
•
g709 otu threshold, page 19
•
g709 tim-to-client-gais, page 21
•
g709 tti-processing, page 22
•
log signal, page 24
•
loopback (DWDM), page 26
•
network connection id, page 28
•
network port id, page 30
•
pm fec report enable, page 32
•
pm fec threshold, page 34
•
pm optics report enable, page 36
•
pm optics threshold, page 38
•
pm otn report enable, page 40
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1