Cisco ASR 9000 Series - Bundle Wait-While

bundle wait-while
To specify the duration of the wait-while timer for a bundle, use the bundle wait-while command in the
bundle interface configuration mode. To disable waiting, use the no form of the command.
bundle wait-while wait-while-time
no bundle wait-while wait-while-time
Syntax Description
Wait-while time, in milliseconds. The range is between 0 to 2000.
wait-while-time
Command Default
The default wait-while time is 2000 milliseconds.
Command Modes
Bundle interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 5.1.3
Usage Guidelines
Task ID
OperationTask ID
read, writebundle
read, writeinterface
Examples
The following example shows how to configure the wait-while time.
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100
RP/0/RSP0/CPU0:router(config-if)# bundle wait-while 20
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
585
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle wait-while