(Optional) Sends a burst of packets
every specified number of seconds,
minutes, or hours, where number
is in the following range:
• 1–3600 seconds
• 1–1440 minutes
• 1–168 hours
The default is to send a burst every
10 seconds.
send burst every number {seconds | minutes | hours}}
Specifies the number of packets to
be sent in a burst, in the range 2 to
600. The default is 10.
packet count number
Specifies the time between sending
packets in a burst, where number
is in the following range:
•
100 to 30000 milliseconds
•
1 to 30 seconds
The total length of a burst
(the packet count
multiplied by the interval)
must not exceed 1 minute.
Note
interval number {milliseconds | seconds}
Minimum size of the packet
including padding when necessary.
The range is 1 to 9000 bytes. This
value is the total frame size
including the Layer 2 or Layer 3
packet header.
packet sizebytes
(Optional) Specifies a 4-byte string
(8 hexadecimal characters) to
repeat as many times as required to
fill the outgoing probe packet to the
specified minimum packet size. The
default is all 0s.
test pattern hex 0x HHHHHHHH
(Optional) Specifies a
pseudo-random bit sequence
determined by the protocol to fill
the outgoing probe packet to the
specified minimum packet size.
test pattern pseudo-random
Specifies the name of the domain
for the locally defined CFM MEP.
domain domain-name
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
233
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-loopback probe
To Next Page
Loading...
Need help?
General
